Cellulose Chemistry and Technology

ADVANCES IN THE CHEMISTRY, PHYSICS AND TECHNOLOGY
OF PULP, PAPER AND CELLULOSE-BASED MATERIALS

ISSN 2457-9459 (Online)
ISSN-L 0576-9787 (Print)


2023

Journal Citation Reports
Impact factor 2023: 1.3
5-Year Impact Factor: 1.2
Article Influence® Score: 0.140
Ranked 9 out of 23
MATERIALS SCIENCE, PAPER & WOOD (Q2)

Scopus
CiteScore 2023: 2.3
SNIP: 0.405

SCImago
SJR: 0.264
H-Index: 42
Ranked Q3

 

Title
Ethanol-water fractionation of sugar cane bagasse catalyzed with acids
Authors
Cristina M. Area Fernando E. Felissia and Maria E. Vallejos

Received May 21, 2009
Published Volume 43 Issue 7-8 July-August
Keywords organosolv, fractionation, kinetics, sugar cane bagasse, acetic acid, sulfuric acid

Abstract
The conditions for maximizing bagasse ethanol-water fractionation (in cellulose, hemicelluloses and lignin) were established by the evaluation of different variables (time, temperature, catalyst). To this end, the organic compounds of the fibrous material and liquors were quantified. Acetic (2 g/L) and sulfuric (0.5, 1.0 and 2.0 g/L) acids were used as catalysts. An alkaline extraction was applied as a pre-treatment, using 3.6 g/L NaOH, at 100 ºC, for 1 h. The effects of different conditions of the organosolv treatment on the kinetics, composition of the fibrous material and residual liquor, upon the fractionation of sugar cane bagasse used in this work, were investigated. The kinetic parameters were determined for delignification under six different conditions. The organic compounds of the fibrous material were quantified and lignin (by UV-visible spectroscopy) and carbohydrates, organic acids, furfural and HMF (by HPLC chromatography) were evaluated in residual liquors. The incorporation of sulfuric acid at 160 ºC produced delignification degrees similar to those obtained by the addition of acetic acid at 180 ºC, or in the fractionation without catalyst (85- 86%). The delignification values showed that fractionations could be stopped at 90 or 120 min, since, after 90 min, the delignification percentage decreases by only about 1%. The incorporation of sulfuric acid extracted a large amount of xylose and produced further degradation of cellulose. Fractionations with acetic acid did not differ largely from the auto-catalyzed ones.


Link

- Full text available Download



Reviewer Information

Editor Information